Introduction
The following quick start guide provides background information about the Honeycomb Ryzen V3000 products which use the Ryzen V3000 System on module.
The guide will give a technical overview about the product and by the end of it you should be able to boot an operating system and begin testing your application.
Revision and Notes
Date | Owner | Revision | Notes |
|---|---|---|---|
| 1.0 |
| |
Table of Contents | |||
Hardware Setup
Product Specifications
| Honeycomb Ryzen V3000 |
|---|---|
I/Os | 3 x USB 2.0 3 x USB 3.0 |
Networking | 2 x SFP+ ports (10GbE each) |
Processor | AMD Ryzen Embedded V3C18I |
Memory & Storage | Up to 64GB DDR5 4800 MTPs |
Misc. | BMC functionality |
Development and Debug interfaces | mini USB |
Power | ATX standard |
Expansion card I/Os | PCIe x4 Gen 4.0 |
Temperature | Industrial: -45°C to 85°C |
Dimensions | PCBA: 170 x 170mm |
Block Diagram **** NEEDS changes ****
The following figure describes the ClearFog LX2162A Block Diagram.
.jpg?version=1&modificationDate=1718531297284&cacheVersion=1&api=v2&width=603&height=442){kind=spacer}
Visual features overview
Please see below the features overview of the HoneyComb AMD V3000 mini ITX
Software Setup
Cable setup and prerequisites
Here is what you will need to power up the board:
Linux or Windows PC
HoneyComb AMD V3000 mini ITX
ATX 60W+
Mini-USB to USB for console, the HoneyComb Ryzen V3000 has an onboard FTDI chip.
IP router or IP switch
Recommended Cables
The following is a list of industry-standard cables, sorted by type, with the necessary compliance requirements that have been proven to work well with the ClearFog product family.
These examples are the cables which SolidRun uses for testing, and should provide enough information to source products from your preferred cable vendor.
Ethernet cable: Monoprice 24AWG Cat6A 500MHz STP
USB Cable: SuperSpeed USB 3.0 Type A Male to Female Extension Cable in Black
SFP connector: GigaLite GE-GB-P1RT-E SFP module with Monoprice 24AWG Cat6A 500MHz STP cable
Booting the machine
Download & install images:
You can use the Ubuntu server installation instructions page or download Pre-installed images.
If using the Pre-installed image, flash it to a USB stick using the following commands:
gunzip <image_name.img.gz> dd if=<image_name.img> of=/dev/sdx bs=1M status=progress; sync
NOTE: check the /dev/sdx device you need using the lsblk command
Booting to OS
Insert the USB stick to the device and power it on.
Wait for the device to boot.
Very first boot might take a while due to DDR training
SFP Modules
For some SFP modules that work on SolidRun networking hardware platforms, please refer to SFP Modules .
SO-DIMM Modules
For some SO-DIMM modules that work on SolidRun hardware platforms, please refer to List of tested SO-DIMMs .
OS list
* HoneyComb AMD V3000 by default is headless and will require additional hardware to install Windows using a display adapter.
** As of JUL 7 2024 (FreeBSD 14.01) the AMD XGBE driver on FreeBSD does not fully support SFP later version will eventually have the driver fixed.
Build From Source
Buildroot image is to be added
Documentation
| File | Modified |
|---|---|---|
Schematics and Board Layout |
| 19-JUN-2024 |
Mechanical files | To be added |