Content Comparison

...

The guide will give a technical overview about the product and by the end of it you should be able to boot an operating system and begin testing your application.

Revision and Notes

Hardware Setup

Product specifications

...

The following shows how to set the switches on the boot source selector:

...

...

1. Downloading the Debian image
   Download the Debian image by running the following command on your Linux/Windows PC:

   Code Block
   wget https://solid-run-images.sos-de-fra-1.exo.io/RZG2LCRZ/Debianrzg2lc_build/sr20231122-6391518/rzg2lc-debiansolidrun-bullseyesd-8471270-cli-rzg2lc-hummingboarddebian-6391518.img.xz

   • For more Debian releases, please visit Debian Releases for RZ/G2LC.

2. Writing the image to the SD card
   Use the following commands for writing the image to an SD card:

   Code Block
   xz -dc sr-rzg2lc-debiansolidrun-bullseyesd-8471270-cli-rzg2lc-hummingboarddebian-6391518.img.xz | dd of=/dev/sdX bs=4k conv=fdatasync

   • For more information, please visit Flashing an SD Card .

   • Note:Plug a micro SD into your Linux PC, the following assumes that the USB-Disk / Micro-SD is added as /dev/sdX and all it’s partitions are unmounted.

3. SD card insertion
   Please Insert the SD card into your device.

4. Power connection
   Connect your power adaptor to the DC jack, and then connect the adaptor to mains supply.

5. Power On
   Hold on the On/Off Power button - SW1 (as shown in the figure below)

   

   • Note: The system should turn on by default when the power is connected (without pressing the button).

6. Serial Connection
   Please insert the micro USB into your device, then you can refer to Serial Connection for installing necessary serial connection software in Linux/Windows.
   Once you installed the necessary serial connection software, you should be able to see the following:

   

• In order to be able to log in , please insert “debian” as a username and password as follows:

  

7. Execute startup script

sudo ~/init_rzg2lc.sh

• Note: Required to enable the Ethernet functionality with the current SW version

8. Final stages

The following stages need to be done in order to finalise the imaging:

...

• For some cellular modules to be connected, please refer to Cellular Modules .

List Of Supported OS

OS
Image Modified	Debian
Image Modified	RZ/G2LC Yocto
Image Modified	Buildroot

Build from source

• https://github.com/SolidRun/build_rzg2lc

Documentation

...