You will need to download an operating system for the HummingBoard Pulse/Ripple and flash in to a blank SD card in order to use the system. You can download official release distributions and find flashing instructions at our software page. If you need help to flash the SD card please see our article Flashing an SD Card .
Before powering up the board for the first time it is recommended to select the boot media. In order to configure the boot media to please reference the below diagram :
The black rectangle represents the switch position. |
Please note , after HummingBoard Pulse/Ripple revision 2.3 and up the dip switch has been changed and the following description applies.
Before powering up the board for the first time it is recommended to select the boot media. In order to configure the boot media to please reference the below diagram :
Before powering up the board for the first time it is recommended to select the boot media. In order to configure the boot media to please reference the below diagram :
