Revisions and Notes
...
You can Install U-Boot binaries from SolidRun Images site.
3. Set the switches on the boot source selector as follows:
...
4. Serial connection
Connect your micro USB cable to your device.
You can refer to the serial connection section in one of our quick start guide pages - Cubox-M, HummingBoard Pulse.
45. Connect the Male to Male USB-A cable to the OTG port on your device.
| Info |
|---|
Identify the OTG port |
Make sure you can detect the USB = NXP Semiconductors in the usb devices list.
56. Use the following commands for loading the U-Boot:
...
The following is an example for i.MX8M-Plus Step-by-step:
1. Once you cloned built the mfgtools project, run the following to install the U-Boot binaries
...
2. Connect your micro USB cable to your device.
3. Connect the USB Male to Male USB-A cable to the UPPER USB OTG port on your device.
Make sure you can detect the USB = NXP Semiconductors in the usb devices list with the exact same vendor ID as shown in the below figure:
...
Then, you should be able to see the following:
...
At this point U-Boot has been loaded to RAM and is running.