...
Date | Owner | Revision | Notes | ||||||||
| Noam Weidenfeld | 1.0 | Initial release | ||||||||
| Yazan Shhady | 1.1 | Add Power Consumption Measurement | ||||||||
Table of Contents |
| ||||||||||
...
Low power and compact size (47x30mm).
4 x Cortex A53 @ 1.3GHz ; 12 kDMIPS.
2 x Cortex M4, 200MHz.
Powerful Neural Network up to 20 TOPS.
High quality multiple sensors ISP pipeline 2 x MIPI-CSI2 4 lanes.
Dual Camera 12MP ISP with HDR H.265/4 Video.
Best AI performance at a standard camera power consumption and cost.
Up to 8Gbytes LPDDR4 (Default 4GB)
Up to 256Gbytes eMMC (Default 32GB64GB)
Bootable 32Mbit QSPI.
A single Gigabit Ethernet interface.
Wi-Fi (802.11a/b/g/n/ac) + BT (5.0) Murata's certified module (Cypress chipset)
On board MIPI-CSI interface supporting Leopard camera's modules.
Industrial temperature grade
...
The voltage on VBUS is 5V.
There are decupling capacitors on the SOM.
PCIe
TBD
MIPI CSI
MIPI CSI interface 1 is available on the BtB connector (See MIPI CSI-2 SOM’s Camera Interface).
...
Single 5V power source.
1.8V output up to 1A (Need to calculate system and SOM power).
Power Consumption
Hailo 15 SOM Power Table:
Test Condition | Voltage | Current | Power | Tj [°C] | Tj [°C] |
|---|---|---|---|---|---|
Idle, Linux up | 5V | 520mA | 2.6W | 64°C | 53°C |
Linux up, Ethernet connected and sending packets by iperf3 | 5V | 620mA | 3.1W | 65°C | 54°C |
Linux up, wifi connected to 2.4GHz and sending packets by iperf3 | 5V | 660mA | 3.3W | 65°C | 54°C |
Linux up, wifi connected to 5GHz and sending packets by iperf3 | 5V | 740mA | 3.7W | 66°C | 55°C |
Linux up, CPU stress to maximum (4 x CPU 100%) | 5V | 700mA | 3.5W | 84°C | 59°C |
Linux up, AI stress Ultra-Performance [*] | 5V | 1.18A | 5.9W | 85°C | 60°C |
All utilities are active in the same time (Wifi, AI stress, CPU stress, Ethernet)[stress running for 1 minute] | 5V | 1.52A | 7.6W | 98°C | 72°C |
All utilities are active in the same time (Wifi, AI stress, CPU stress, Ethernet)[stress running for 3 minutes] | 5V | 1.56A | 7.8W | 116°C | 82°C |
Power and thermal tests were conducted at room temperature.
[*] AI Stress by running hailortcli run apps/detection/resources/yolov5m_wo_spp_60p_nv12_640.hef --power-mode ultra_performance
Reset
The Hilo 15 power is monitored by a voltage supervisor.
...
The Hailo 15 uses some GPIO signals for its internal controls. Some of the signals are of the CPU and others are of the IO Expender. The following table describes the GPIO allocation.
Signal | I/O | Description | Remarks |
H_GPIO_6 | H_GPIO_6 | Reset the IO Expander | Active Low |
H_GPIO_8 | H_GPIO_8 | IO Expander interrupt | Active Low |
WL_REG_ON | IO_EXP 0-1 | Enable the WIFI radio | Active High |
BT_REG_ON | IO_EXP 0-2 | Enable the BT radio | Active High |
ETH_RST# | IO_EXP 0-3 | Reset the Ethernet PHY | Active Low |
ENET_nINT | IO_EXP 0-4 | Ethernet PHY interrupt | Active Low |
QSPI_SEL | IO_EXP 0-4] | Select the QSPI interface | “0” FLASH memory “1” Board to Board conn. |
Hailo 15 SOM Debugging Capability
...
Hailo 15 Typical Power Consumption
TBD
Hailo 15 SOM Mechanical Description
...
Federal Communications Commission (FCC) Statement
TBD