| Note |
|---|
The documentation for SolidSense software is not maintained by SolidRun and the information herein is not actual with the latest version of the software, please contact our partner SolidSense Connect who is now developing the SolidSense software. |
Foreword
This article describe the procedure to flash the Wirepas stack on one or both of the of the Nordic chip available for that purpose on the gateway. This procedure is provided only for Wirepas licensees (having a full development license) that are flashing the sinks part of their license. For user not having a Wirepas development license they shall buy the gateways with the Wirepas stack installed by SolidRun.
...
Here is the table of the pin assignment to be used in the firmware
Model/Chip | Direction | Pin |
|---|---|---|
Indoor/Nina B1 | TX | 6 |
Indoor/Nina B1 | RX | 5 |
Outdoor or Industrial /Nina B3 | TX | 45 |
Outdoor or Industrial /Nina B3 | RX | 29 |
Baud rate used for connection is : 125000. This is to match with the Sink Service
...
After flashing the simplest solution to enable Wirepas is to use the https://solidrun.atlassian.net/wiki/spaces/developer/pages/263946241/Configuring + and + testing + the + Wirepas + gateway +software#Prerequisitesoftware | Prerequisite-and-installation .
Flashing the Wirepas sink for upgrade
...
After that operations it is necessary to re-configure the sink with the right values and re-start the transport (data) service. This needs to be done via the web interface: https://solidrun.atlassian.net/wiki/spaces/developer/pages/263946241/Configuring + and + testing + the + Wirepas + gateway +software#Configuringsoftware | Configuring-the-sink-service-with-Kura .
Once the sink(s) have been configured, then the transport service can be restarted either via the web interface, Or directly via the systemctl command.