Versions Compared

Version Old Version 15 New Version 16
Changes made by

Yazan Shhady

Shahar Fridman

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The following shows how to set the switches on the boot source selector:

...

Info

Please Note:

The black rectangle represents the switch position.

...

  1. Downloading the Debian image
    Download the Debian image by running the following command on your Linux/Windows PC:

    Code Block
    wget https://solid-run-images.sos-de-fra-1.exo.io/RZ/rzg2lc_build/20231122-6391518/rzg2l-solidrun-sd-debian-6391518.img.xz

  2. Writing the image to the SD card
    Use the following commands for writing the image to an SD card:

    Code Block
    xz -dc rzg2l-solidrun-sd-debian-6391518.img.xz | dd of=/dev/sdX bs=4k conv=fdatasync

    • For more information, please visit Flashing an SD Card .

    • Note:Plug a micro SD into your Linux PC, the following assumes that the USB-Disk / Micro-SD is added as /dev/sdX and all it’s partitions are unmounted.

  3. SD card insertion
    Please Insert the SD card into your device.

  4. Power connection
    Connect your power adaptor to the DC jack, and then connect the adaptor to mains supply.

  5. Power On
    Hold on the On/Off Power button - SW1 (as shown in the figure below)

    • Note: The system should turn on by default when the power is connected (without pressing the button).

  6. Serial Connection
    Please insert the micro USB into your device, then you can refer to Serial Connection for installing necessary serial connection software in Linux/Windows.
    Once you installed the necessary serial connection software, you should be able to see the following:

...

To discover your wireless network interface name, see Network Interfaces.

  1. Install the wpa_supplicant package:

Code Block
apt-get install wpasupplicant

  1. Edit network interfaces file :

At the bottom of the file, add the following lines to allow wlan as a network connection:

Code Block
cat <<EOF > /etc/network/interfaces.d/wlan0
allow-hotplug wlan0
iface wlan0 inet dhcp
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
iface default inet dhcp
EOF

  1. Create a configuration file with the relevant ssid:

Code Block
cat <<EOF > /etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=/run/wpa_supplicant
update_config=1
network={
    ssid="MYSSID"
    psk="passphrase" 
}
EOF

Check your personal ssids by running : ‘iw dev wlan0 scan’

  1. Make sure it works:

Restart your device and it should connect to the wireless network. You can check it by running the command $ iwconfig . If it doesn't, repeat above steps or get help from an adult.

...