Versions Compared

Version Old Version 19 New Version 20
Changes made by

Lior Jigalo

Lior Jigalo

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Expand
titleDebug Port Table Configuration

  • Debug Port Table: Disabled / Enabled

  • Debug Port Table 2: Disabled / Enabled

  • WARNING:
    Changing Device(s) Option ROM dispatch policy may affect system’s ability to post and/or boot!
    PROCEED WITH CAUTION!

Expand
titleOption ROM Dispatch Policy

  • Restore if Failure: Disabled / Enabled (ifenaabled and system fails to boot it will restore this and CSM screens settings to default)

  • Primary Video Ignore: Disabled / Enabled

  • On Board Network Controller: Disabled / Enabled

  • Slot #32 Mass Storage Controller: Disabled / Enabled

  • Slot #33 Mass Storage Controller: Disabled / Enabled

  • Slot #34 Network Controller: Disabled / Enabled

  • Slot #49 Network Controller: Disabled / Enabled

  • Slot #51 Network Controller: Disabled / Enabled

  • WARNING:
    Changing PCI Device(s) settings may have unwanted side effects! System may HANG!
    PROCEED WITH CAUTION.

Expand
titlePCI Subsystem Settings

  • Above 4G Decoding: Disabled / Enabled

  • Re-Size BAR Support: Disabled / Enabled

  • SR-IOV Support: Disabled / Enabled

  • BME DMA Mitigation: Disabled / Enabled

  • Hot-Plug Support: Disabled / Enabled

Expand
titleUSB Configuration

  • Legacy USB Support: Disabled / Enabled

  • XHCI Hand-off: Disabled / Enabled

  • USB Mass Storage Driver Support: Disabled / Enabled

  • USB transfer time-out: 1 sec / 5 sec / 10 sec / 20 sec

  • Device reset time-out: 10 sec / 20 sec / 30 sec / 40 sec

  • Device power-up delay: Auto / Manual (opens another option)

    • Device power-up delay in seconds: [your custom delay]

  • list of USB mass storage devices with option to choose their type:
    Auto / Floppy / Forced FDD / Hard Disk / CD-ROM

...

Expand
titleAMD CBS

  • CPU Common Options:

    • Prefetcher settings:

      • L1 Stream HW Prefetcher: Auto / Disabled / Enabled

      • 2 Stream HW Prefetcher: Auto / Disabled / Enabled

    • Core Watchdog:

    • Core Watchdog Timer Enable: Disabled / Enabled (opens more options)

      • Core Watchdog Timer Interval: Auto / 21.461s - 39us

      • Core Watchdog Timer Severity:
        Auto
        Fatal
        Uncorrected
        Deferred
        Corrected
        Transparent
        No Error

    • CCD/Core/Thread Enablement:

      • Core control: Auto / ONE / TWO / THREE / FOUR / FIVE / SIX / SEVEN

    • RedirectForReturnDis: Auto / 0 / 1

    • Core Performance Boost: Auto / Disabled

    • lobal C-state Control: Auto / Disabled / Enabled

    • Opcache Control: Auto / Disabled / Enabled

    • SEV ASID Count: Auto / 253 ASIDs / 509 ASIDs

    • SEV-ES ASID Space Limit Control: Auto / manual (opens another option)

      • SEV-ES ASID Space Limit: [manual]

    • Streaming Stores Control: Auto / Disabled / Enabled

    • Local APIC Mode: Auto / xAPIC / x2APIC

    • ACPI _CST C1 Declaration: Auto / Disabled / Enabled

    • MCA error thresh enable: True / False

    • MCA error thresh count: FF5 (default) [manual]

    • SMU and PSP Debug Mode: Auto / Disabled / Enabled

    • PPIN Opt-in: Auto / Disabled / Enabled

    • Action on BIST Failure: Auto / Down-Core / Do nothing

    • IBS hardware workaround: Auto / Down-Core / Do nothing

  • DF Common Options:

    • Scrubber:

      • DRAM scrub time(hours): Auto / Disabled / 1h / 4h / 8h / 16h / 24h / 48h

      • Poison scrubber control: Auto / Disabled / Enabled

      • Redirect scrubber control: Auto / Disabled / Enabled

      • Redirect scrubber limit: Auto / Infinite / 2 / 4 / 8

      • DRAM map inversion: Auto / Disabled / Enabled

    • Memory Addressing:

      • Memory interleaving size: Auto / 256 Bytes / 512 Bytes / 1 KB / 2 KB

    • CC6 memory region encryption: Auto / Disabled / Enabled

    • Memory Clear: Auto / Disabled / Enabled

    • Disable DF to external downstream IP SyncFloodPropagation: Auto / Sync flood enabled / Sync flood disabled

    • Disable DF sync flood propagation: Auto / Sync flood enabled / Sync flood disabled

    • Freeze DF module queues on error: Auto / Disabled / Enabled

    • DF Cstates: Auto / Disabled / Enabled

  • UMC Common Options:

  • NBIO Common Options:

  • FCH Common Options:

  • SMU Common Options:

    • System Configuration (TDP): Auto / 10W / 15W / 25W / 35W / 45W / 54W

    • Sustained Power Limit: [manual]

    • PPT Control: Auto / Manual (opens manual value input option)

    • STAPM Control: Auto / Manual (opens manual value input option)

    • Thermal Control: Auto / Manual (opens manual value input option)

    • TDC Control: Auto / Manual (opens manual value input option)

    • EDC Control: Auto / Manual (opens manual value input option)

    • PSI3 Control: Auto / Manual (opens manual value input option)

    • PROCHOT Control: Auto / Manual (opens manual value input option)

    • STT Control: Auto / Manual (opens manual value input option)

    • Fan Control: Auto / Manual (opens manual value input option)

    • VDDP Voltage Control: Auto / Manual (opens manual value input option)

    • VDDM Voltage Control: Auto / Manual (opens manual value input option)

    • SmartShift Control:

      • SmartShift Control: Auto / Manual(opens more options)

        • SmartShift Enable: Auto / Disabled / Enabled

        • APU Only sPPT Limit: [manual]

        • Sustained PowerLimit: [manual]

        • Fast PPT Limit: [manual]

        • Slow PPT Limit: [manual]

    • Zstates (Z9 and Z10): Auto / Disabled / Enabled

  • SOC Miscellaneous Control:

    • PSP RPMC Switch: Auto / Disabled / Enabled

    • Firmware Anti-rollback (FAR):

      • Initial SPL value for FAR: [manual]

      • FAR Switch: Disabled / Enabled

    • Rom Armor support: Auto / Disabled / Enabled

    • ABL Console Out Control: Auto / Disabled / Enabled

    • Secured-core Auto enablement: Auto / Disabled / Enabled

    • Pluton (HSP) Options:

      • Pluton (HSP) X86 Firmware Support: Auto / Disabled / Enabled

      • Pluton (HSP) UART: Auto / Disabled / Enabled

      • Pluton (HSP) FIPS: Auto / Disabled / Enabled

      • Pluton (HSP) ACPI Fence Enable: Auto / True / False

    • AIM-T Options:

      • AGESA MPM support:

        • KVM for Wired Manageability: Auto / Disabled / Enabled

        • Wireless Manageability: Auto / Disabled / Enabled (opens more options)

          • KVM for Wireless Manageability: Auto / Disabled / Enabled

          • TCR for Wireless Manageability: Auto / Disabled / Enabled

    • Intrusion Detection:

      • Intrusion Detection settings: [manual] requires password to show settings

    • Mixed DIMM config extended NUMA domain: Auto / Disabled / Enabled

  • Displays 4 Intel NICs if they are present and flashed:

    • when chosen displays brief NIC info, link status and MAC address.

  • Driver Health: displays Intel NICs driver status: Healthy / Not Healty.

Image Modified

  • Chipset screen:

Expand
titlesubmenus

  • South Bridge:

    • SB USB configuration, enable disable different USB port options.

  • GFX Configuration:

    • NOT SUPPORTED

  • North Bridge:

    • DDR Memmory data.

...