Revisions and Notes
...
4. Connect the Male to Male USB-A cable to the OTG port on your device.
| Info |
|---|
Identify the OTG port |
...
2. Connect your micro USB cable to your device.
3. Connect the USB Male to Male USB-A cable to the UPPER USB OTG port on your device.
Make sure you can detect the USB = NXP Semiconductors in the usb devices list with the exact same vendor ID as shown in the below figure:
...
Then, you should be able to see the following:
...
At this point U-Boot has been loaded to RAM and is running.