Content Comparison

...

You can Install U-Boot binaries from Solid-Run images site - https://images.solid-run.com/IMX8/U-Boot.

3. Serial connection

Connect your micro USB cable to your device.

• You can refer to the serial connection section in one of our quick start guide pages - HummingBoard Pulse.

4. Connect the USB to USB cable to the USB OTG port on your device.

• Make sure you can detect the USB = NXP Semiconductors in the usb devices list.

5. Use the following commands for loading the U-Boot:

cd <DIRPATH>/mfgtools/uuu/
sudo ./uuu <flash.bin-dir>/flash.bin

• For more information about the uuu tools, you can refer to https://github.com/NXPmicro/mfgtools

i.MX8M-Plus

...

Example

Here is an example for i.MX8M-Plus Step-by-step:

1. Once you cloned the mfgtools project, run the following to install the U-Boot binaries

wget https://solid-run-ignition.sos-de-fra-1.exo.io/imx8mp/Buildroot/flash-uboot-1g-and-3g.bin

• You can build your own image using the runme.sh script here – https://github.com/SolidRun/imx8mp_build. The flash.bin should be under  $ROOGitHub - SolidRun/imx8mp_build: IMX8M Plus buildroot build script​.TDIR/build/imx-mkimage/iMX8M/flash.bin

32. Serial connection Connect your micro USB cable to your device.

• You can refer to the serial connection section in one of our quick start guide pages - HummingBoard Pulse.

43. Connect the USB to USB cable to the USB OTG port on your device.

• Make sure you can detect the USB = NXP Semiconductors in the usb devices list with the exact same vendor ID as shown in the following examplebelow figure:

...

5. Use the following commands for loading the U-Boot4. Change your current working directory:

cd <DIRPATH>/mfgtools/uuu/

Then you should be able to see the following:

...

5. Load the U-Boot:

sudo ./uuu <flash.bin-dir>/flash.bin

Then you should be able to see the following:

...

-uboot-1g-and-3g.bin