...
...
Introduction
This guide contains tips and resources for a quick start with IMX8MP HummingBoard Pro and Hailo-8 AI accelerator.
Revision and Notes
Date | Owner | Revision | Notes | ||||||
|---|---|---|---|---|---|---|---|---|---|
| Yazan Shhady | 1.0 | Initial release | ||||||
| Josua Mayer | 1.1 | Fix boot select switch setting for microSD | ||||||
Table of Contents |
| ||||||||
Setup
Cable setup and prerequisites
...
For more information, please visit Flashing an SD Card.
Note: Plug a micro SD into your Linux PC, the following assumes that the micro SD is added as /dev/sdX and all its partitions are unmounted.
...
Before powering up the board for the first time , it is recommended to select the boot media. To configure the boot mediaOn first use microSD is recommended source, configure dip switch S3 as follows:
Function/Switch | 1 | 2 | 3 | 4 | 5 | 6 |
|---|---|---|---|---|---|---|
microSD | ON | ON | X | X | X | X |
“X” means don’t care, leave as is.
For additional options, please refer to HummingBoard Pulse and Ripple i.MX8M Series HummingBoard Boot Select page.
Here is the correct DIP switch position for SD boot:
...
Booting from SD card
The following shows how to set the switches on the boot source selector:
...
| Info |
|---|
Note: The black rectangle represents the switch position. |
Once you set the switches, you can apply the following for booting from an SD card.
Preparing the board
Ensure the Hailo-8 M.2 module with a heatsink is installed into the M.2 connector on the bottom of the board.
Connect an HDMI and micro USB cable.
Insert an SD card into the board.
[optional] Connect the MIPI camera to the MIPI interface.
...
Boot
Please refer to Serial Connection for installing the necessary serial connection software in Linux/Windows. You are ready to boot the board once you have installed the required serial connection software. Plug the DC power supply. The board will start booting, and you will see the boot log in your terminal.
...